This first guide is for the first version of Redsnow. The post further below under the heading Redsnow V0.7.2 is for the second version, which is the most current. I used the first version, so I will try to answer questions about the second version, however I will not be able to give you a definate answer.
Redsnow V 0.7.1 Guide
Make sure that your iPhone is upgraded to 3.0 through iTunes 8.2
Note: Method Two is a lot quicker then Method 1. It is technically the same, however you skip Step 5 - Step 7.
Method One
Step 1. Download 0.7.1 at
http://thepiratebay.org/torrent/4965...sn0w-win_0.7.1
Step 2. Extract redsn0w-win_0.7 to C:
Step 3. Locate your 3.0 firmware, and copy it to C:\redsn0w-win_07
Step 4. Open run, then type cmd.
Step 5. Type in cd C:\redsn0w-win_07
Step 6. Type redsn0w.exe (the name of the ipsw).
Eg for Step 6. redsn0w.exe iPhone1,2_3.0_7A341_Restore.ipsw
Step 7. Wait for a message to come up saying please connect your iPhone into DFU mode.
Then connect your iPhone to the computer if you havent already done so, and hold down
the Power and Home buttons for 10 sec. (If the apple screen comes up you have gone too far)
Then let go of the Power but keep holding onto the Home button. Hold it for at least 30 sec or
until it reconnects to the computer.
Step 8. Go to the Command Prompt window and press enter.
And then when your iphone restarts, you can disconnect.
Method Two
Step 1. Download 0.7.1 at
http://thepiratebay.org/torrent/4965...sn0w-win_0.7.1
Step 2. Extract redsn0w-win_0.7 to C:
Step 3. Locate your 3.0 firmware, and copy it to C:\redsn0w-win_07
Step 4. Drag and drop 3.0 firmware onto redsn0w.exe
Step 5. Wait for a message to come up saying please connect your iPhone into DFU mode.
Then connect your iPhone to the computer if you havent already done so, and hold down
the Power and Home buttons for 10 sec. (If the apple screen comes up you have gone too far)
Then let go of the Power but keep holding onto the Home button. Hold it for at least 30 sec or
until it reconnects to the computer.
Step 6. Go to the Command Prompt window and press enter.
Redsnow V0.7.2
For an indepth guide on how to jailbreak using 0.7.2, go here:
http://iclarified.com/entry/index.php?enid=4301
How to Unlock with Ultrasn0w.
FOR 3G ONLY
1.Ensure you have upgraded to iPhone OS 3.0
2.Jailbreak your iPhone 3G using redsn0w or PwnageTool (this will also install Cydia/Icy)
3.Run Cydia or Icy
4.Please add the repo repo666.ultrasn0w.com to Cydia or icy
5.Search for ‘ultrasn0w’ in cydia or icy and install ultrasn0w
6.Reboot your iPhone 3G
7.T-Mobile USA users should disable 3G before using ultrasn0w
8.Enjoy
If you have any questions you can just ask. Please post to tell me if it works for you.